D-Link Forums
D-Link VPN Router => DSR-500N => Topic started by: adelmof on September 08, 2017, 06:05:43 AM
-
i´m have an dsr500 with same problem...
I have a strange DSR-500N failover issue. When connected on both WAN1 and WAN2, it takes nearly 4 minutes incase of a failover. After extensive testing I somewhat managed to conclude that if there is any session which is going on, it fails to perform a successive failover (possibly due to some NAT issue). If there are absolutely no sessions going on (not even a ping) only then it manages within 30secs or so (but I cannot conclude the exact time as if i ping and the failover isnt complete then it takes more than 2 mins). Has anyone else experienced the same problem where it takes as long as 4 mins for a failover or am I going wrong with my configurations?
Firmware Version: 1.03B43_WW
Thanks
-
Link>Welcome! (http://forums.dlink.com/index.php?topic=48135.0)
- What Hardware version is your router? Look at sticker under the router case.
- Link>What Firmware (http://forums.dlink.com/index.php?topic=47512.0) version is currently loaded? Found on the routers web page under status.
- What region are you located?
Internet Service Provider and Modem Configurations
- What ISP Service do you have? Cable or DSL?
- What ISP Modem Mfr. and model # do you have?
- Is ISP Modem/Service using Dynamic or Static WAN IP addressing?