D-Link Forums

The Graveyard - Products No Longer Supported => Access Points / Extenders => DAP-1522 => Topic started by: drshock on September 13, 2015, 08:10:39 AM

Title: IPv6 Support
Post by: drshock on September 13, 2015, 08:10:39 AM

I have a DAP-1522 rev A1 with last firmware available installed, 1.42.    I did not replace it when switching over to IPv6 because this D-Link list at the bottom Q&A states it supports IPv6 - http://us.dlink.com/technology/dlink-ipv6-solutions/

I noticed I do not see the IPv6 configuration options in my firmware UI that are shown starting on page 24 here either - http://www.dlink.com/-/media/Consumer_Products/DAP/DAP%201522/Manual/DAP%201522_Manual_EN_US.pdf

Is it possible that only the rev B hardware supports IPv6 and not the A rev?  If so, this should be clarified at the D-Link USA support site.

Title: Re: IPv6 Support
Post by: FurryNutz on September 13, 2015, 10:49:43 AM

The DAP-1522 is based on similar HW as the DIR-655 Rev A. Both were succeeded with Rev B versions as well and I know that Rev B 655 supported IPv6. Rev A did not and I presume that Rev A DAP-1522 is the same. Most Rev A models of that time frame did not support IPv6.