D-Link Forums

The Graveyard - Products No Longer Supported => IP Cameras => DCS-2332L => Topic started by: Champion on May 10, 2015, 02:21:00 PM

Title: Motion dedection
Post by: Champion on May 10, 2015, 02:21:00 PM

can anybody tell me what are the orginial values for motion dedection?
what are the best to wath a huge area outside (a lot of false alarms)...

Title: Re: Motion dedection
Post by: walkjp1 on May 11, 2015, 12:57:55 AM

The original settings are 85 sensitivity, 5 percentage.  I have never found a setting the does not produce a lot of false alarms.

Title: Re: Motion dedection
Post by: Champion on May 11, 2015, 03:19:09 AM

thanks

Title: Re: Motion dedection
Post by: rstark18 on May 11, 2015, 01:27:41 PM

I didn't have a lot of success with motion detection but I'm very satisfied with PIR detection.

Title: Re: Motion dedection
Post by: walkjp1 on May 21, 2015, 07:32:25 PM

Can you give us some info on what seetings you used for PIR? I tried it and did not get good response. But maybe that is because it is always HOT where I live?

Title: Re: Motion dedection
Post by: rstark18 on May 21, 2015, 08:21:43 PM

U'm still running 1.01 firmware so there isn't any settings for PIR, just on or off. I don't want to risk installing 1.05 because 1.01 is running so good for me.

Title: Re: Motion dedection
Post by: RYAT3 on May 22, 2015, 06:47:28 AM

Quote from: walkjp1 on May 21, 2015, 07:32:25 PM

Can you give us some info on what seetings you used for PIR? I tried it and did not get good response. But maybe that is because it is always HOT where I live?

Pir doesn't work behind windows in case that's your problem.

I guess if it is 110f out, pir might have issues too. Never thought of that.