D-Link Forums
The Graveyard - Products No Longer Supported => Routers / COVR => DIR-890L => Topic started by: mrkennethtong on February 14, 2015, 07:26:06 AM
-
How do I use this as a Range Extender? I have two and would like to place another in a marginally strong area and extend the Network, but this being new, it is not apparent!
-
Can try this:
Turning a router into an AP. (http://forums.dlink.com/index.php?topic=40856.0)
I know there is AP mode on the router which I believe set up the same as above...I don't think Bridge mode is supported as of yet or will be.
-
Have followed the link but MUST I do the instruction with the SSID or can I just enable Smart Connect on both routers?
-
Being that SC is new and is a automatic feature, I presume it may or may not work right. Since the 2 routers should be on different channels and can use the same SSID in the normal way of setting up a 2ndary AP, I'm not sure how SC will behave and react to another SC feature being used on the wired AP. You can try it and see how it works. I would recommend disabling SC on both and manually setting up the radios with manual channels that differ and test that out.
Have followed the link but MUST I do the instruction with the SSID or can I just enable Smart Connect on both routers?
-
You are the best, will do all this later and hope it works!
-
Smart Connect Technology (http://forums.dlink.com/index.php?topic=62072.0)
Let us know how it works out... ;)
-
With the latest release of the firmware and a sanctioned AP-Mode, I can simply enable this now no?
-
SC can be disabled or enabled. Up to you the user on how you wish to use the router.