D-Link Forums
The Graveyard - Products No Longer Supported => IP Cameras => DCS-932L => Topic started by: wavemaster on January 26, 2015, 08:59:54 AM
-
I have 3 DCS-932L cameras that I am trying to set up.
Found the reset button on the back and used a paperclip to reset the camera which it does after about 6 sec of holding the reset button down.
DVD with the Dlink Setup Wizard in the computer and I am at the Set your camera's password. Put in the password and click on next.
My router does not have WPS so it is connected by Ethernet cable to the network.
"Saving settings, please wait..... "
Comes back after a while with a message "there was a problem saving your settings, click next to try again"
Admin Id: admin which I cannot change.
Tried it many times no, still no luck.
Where to go from here?
-
Log directly into the cameras firmware and change the password in there
-
As RYAT suggested, you should try the Wed UI. Please see the following sticky post for detailed steps:
Network Cameras - Important Posts & Information (http://forums.dlink.com/index.php?topic=58121.0)