D-Link Forums

The Graveyard - Products No Longer Supported => Access Points / Extenders => DAP-1320 => Topic started by: SFOUGERE on February 22, 2014, 07:31:08 PM

Title: Need to Filter DAP-1320 by MAC Addresse
Post by: SFOUGERE on February 22, 2014, 07:31:08 PM

I bought a DAP-1320 this month. I would like to use MAC Address on my Wireless Router. - This is Monitory as I work from home.  I configured the DAP-1320, then I put the MAC Address I found on the box in my Asus Router.  When I enable the MAC Address filter on my Router, I cannot connect to the DAP-1320.

When I disabled the MAC Address filter all went great.

From what I previously read in this forum that was put by dph30555, it seems that there is a 2nd MAC Address for the Extended Wi-Fi.

Is that so,if yes - where can I find this other MAC Address or is there a way to know where to find it.

Thanks

Title: Re: Need to Filter DAP-1320 by MAC Addresse
Post by: FurryNutz on February 23, 2014, 10:12:16 AM

Link>Welcome! (http://forums.dlink.com/index.php?topic=41537.0)

• What Hardware version is your DAP? Look at sticker under DAP.
• Link>What Firmware (http://forums.dlink.com/index.php?topic=47512.0) version is currently loaded? Found on the DAPs web page under status.
• What region are you located?

IF this unit is handing out 2 MACs and 2 IPs for it's connection, you'll need to look at your DHCP dynamic IP clients list on the main host router for these IP addresses and if the router supports it, should display the MAC addresses. You should see the MAC address listed on the box or the back of the unit, then there should be another listed as well, you might have to find this by trial and error by turning off the DAP. Look at the routers list and take not of whats there. Then turn ON the DAP and let it connect, then review or refresh the routers list again, then see what is displayed there.

Title: Re: Need to Filter DAP-1320 by MAC Addresse
Post by: FurryNutz on March 03, 2014, 11:45:35 AM

Any status on this?  ???