D-Link Forums
The Graveyard - Products No Longer Supported => IP Cameras => DCS-942L => Topic started by: zentaco on May 18, 2013, 07:18:58 PM
-
I have 2 cameras, both model DCS-942L/A3. Let's call them "Camera-A" and "Camera-B".
Both cameras are working and can be viewed on-line from mydlink.com.
Both cameras are on the same network, but Camera-B is plugged into a Wi-Fi Range Extender (Amped Wireless REC10). The range extender is plugged into a power outlet and Camera-B is plugged into it via a CAT-5 cable.
ISSUE: On mydlink.com, when I go into the settings for Camera-B, which is connected through the Wi-Fi range extender, the video and picture for Camera-A is being shown. Everything else is correct - the IP, recording settings, etc are for Camera-B, but the video and picture is from the other camera. Which means I can't change the motion detection area because it's the wrong image. Also, motion detection is not working for Camera-B. It shows the microSD card and I can format it, but it's not recording anything.
Not that it matters, but it's the same result using IE, FireFox, Chrome, Opera.
When initially setting up the cameras, I installed Camera-A first, then Camera-B two days later. When installing/setting up Camera-B on the local network (with my laptop), using the dcs942L setup wizard, everything worked. The second camera was detected and the video/picture settings were correct.
Going to try removing the Wi-Fi Range Extender and plugging Camera-B straight into the router like Camera-A. I'll post my results..