D-Link Forums
		The Graveyard - Products No Longer Supported => IP Cameras => DCS-932L => Topic started by: mikael2235 on February 20, 2012, 03:38:30 AM
		
			
			- 
				Hi all, 
 
 I bought last week, a pack of 2 DCS-932L. And I have connected them to my network by wireless to a D-Link DI524UP.
 
 Now I can see in Network (Windows7), or when I'm using Surveillance Station (Synology) that the cameras are continuously disconnecting and reconnecting from my network.
 
 Actually, I can't use them.
 
 Do you think it can be a configuration problem in cameras ? or a problem form the DI524UP ?
 Could you help me ?
 
 Thanks.
- 
				Hi all, 
 
 I bought last week, a pack of 2 DCS-932L. And I have connected them to my network by wireless to a D-Link DI524UP.
 
 Now I can see in Network (Windows7), or when I'm using Surveillance Station (Synology) that the cameras are continuously disconnecting and reconnecting from my network.
 
 Actually, I can't use them.
 
 Do you think it can be a configuration problem in cameras ? or a problem form the DI524UP ?
 Could you help me ?
 
 Thanks.
 
 
 You can try using a static IP address, but that will likely give you issues if you're using mydlink.
- 
				I already use Static IP for my cameras, because I'm using Surveillance Station from my Synology NAS.
 
 Why will I have problem with my d-link if I'm using Static IP ?
 
 Thanks.
- 
				I already use Static IP for my cameras, because I'm using Surveillance Station from my Synology NAS.
 
 Why will I have problem with my d-link if I'm using Static IP ?
 
 Thanks.
 
 
 I've seen many users writing (on these boards) that static IP addresses provide stability for LAN viewing, but cause issues with the mydlink website.  Something related to UPnP/WPS.  ???
- 
				I have 1 camera inside and the other outside. 
 The camera #2 which is inside has no problem. But outside camera #1 often disconnect and reconnect.
 
 So I have just tried to change the 2 cameras (but not the alimentation). The #2 is outside and #1 inside. And now the #2 is disconnecting and reconnecting. and not the #1.
 
 Actually outside temperature is about 10°C. And on D-link datasheet, the temperature for a normal functionning is 0~40°C. So I don't know why I have this problem ?
 
 Thanks.