D-Link Forums
		The Graveyard - Products No Longer Supported => Routers / COVR => DIR-655  => Topic started by: Alemaker on August 21, 2007, 06:08:57 AM
		
			
			- 
				Hi, 
 Just bought a DIR-655 and am generally VERY happy with it. Updated the firmware to 1.05 right at setup, but here's my question.
 When I'm the only one tx/rx on the wlan, speeds are outstanding, when my son logs on also, it totally slows me to a crawl-takes forever to load pages, etc. I'm Wi-FI N and he's G and have the router set to GN only. Not sure why this is happening-
 More info-the internet connection is from a comcast cable modem to the dir-655-set up with wpa2, and no other changes from default.
 
 Am I missing something? I asked him what he was doing, and at the time he said dloading his iTunes. Any help?
 
 ???
- 
				Any use of G cards on the network causes the system to operate at G speeds max only.  The N/G radio switches modes when it detects a G device.  You should upgrade all your cards to N.
			
- 
				 Thanks for that info   ;D  -but what I'm seeing is serious degradation of speed for me-not just down to 54Mbps-that would be acceptable-it's causing me to load pages at less than dial-up speeds, takes like 5 minutes for me to load a page, while he operates just fine? He has the Intel 3945ABG and I have the Intel 4965 N both with the newest drivers?
			
- 
				Change the channel width to 20 instead of 20/40. 
 Intel cards are silliy like that.
 
- 
				great- I'll try that.
 One other question?
 Do I need to set the card in the laptops from auto to 20 only too?
 ???
- 
				Lycan,
 THX-that did it!!!!!!!!!!!!  ;D Haven't been able to test it till just now when my son got home, but yup, switching the DIR-655 to 20MHz only solved my download problems!!!!!! Thanks again. ;)
 
- 
				Change the channel width to 20 instead of 20/40. 
 Intel cards are silliy like that.
 
 
 
 Agreed Automatic is not your friend
 
 use WPA2 only mode also,  that will boost speeds.
- 
				ya made me think-but, yup I'm WPA2 AES only!!!
 ;D
 
 Thx everyone for your help, ohh, and since he'll be going off to school soon, I'm going back to N only soon too! 8)
- 
				Auto mode is only used with D-Link adapters top achieve the theoretical 300Mbps. 
 
- 
				okey dokey-
 thx for the clarification!
 ;D