D-Link Forums

D-Link IP Cameras for Home => DCS series Network Cameras => Topic started by: brassballs on February 13, 2011, 10:14:06 AM

Title: DCS-2100+ How to change from wired to wireless?
Post by: brassballs on February 13, 2011, 10:14:06 AM

I'm trying to re-setup this EOL camera on a new router.

I've been able to reset the cam to factory defaults and see it wired using dhcp.  I then was able to change the address to a static address, still wired and still can see it with IE.  However when I disconnect the rj-45 cable, power down and restart, I can't access the cam.

If I plug the cable back in it reappears.

Can anyone provide a step by step how to?  I've done this once before many years ago but didn't write down how to.  The cam manual doesn't provide much help.

Thanks.

Title: Re: DCS-2100+ How to change from wired to wireless?
Post by: capt_d on April 09, 2011, 11:20:13 PM

do you know where I can get the instalation cd for the dcs-2100+ camera

Title: Re: DCS-2100+ How to change from wired to wireless?
Post by: capt_d on April 10, 2011, 08:52:33 PM

http://www.dlink.co.uk/cs/Satellite?c=TechSupport_C&childpagename=DLinkEurope-GB%2FDLTechProduct&cid=1197319188567&p=1197318962293&packedargs=category%3DTechSupportSearch%26locale%3D1195806691854%26term%3DDCS-2100%252B&pagename=DLinkEurope-GB%2FDLWrapper 

 ( that is where i found  downloads)