D-Link Forums

The Graveyard - Products No Longer Supported => Routers / COVR => DIR-655 => Topic started by: wcsjohn on August 22, 2010, 03:58:10 PM

Title: 655 set to bridge mode, can't remember IP, not sure how to connect
Post by: wcsjohn on August 22, 2010, 03:58:10 PM

I've got a DIR-655 set in bridge mode after a Cisco router.  It's been working great for months, but now I'd like to add a new wireless device and want to get the settings.  For the life of me, I can't remember how to access it now.

The subnet is 192.168.2.XXX

I've got a Mac connected through the "internet" port and a cat5 cable.  I figure I should be able to go from 192.168.2.1 through 192.168.2.254 and will eventually find it.  Is there something I'm missing?

Title: Re: 655 set to bridge mode, can't remember IP, not sure how to connect
Post by: wcsjohn on August 22, 2010, 04:19:43 PM

I guess it's in AP mode because the 655 doesn't have a bridge mode.  Same question though, how do I find the admin?

Title: Re: 655 set to bridge mode, can't remember IP, not sure how to connect
Post by: Dalmo on August 22, 2010, 06:39:19 PM

should be 192.168.0.1



 ;D

Title: Re: 655 set to bridge mode, can't remember IP, not sure how to connect
Post by: !!!!clarkkent on August 22, 2010, 07:01:14 PM

What port on the DIR-655 is your Cisco router connected to?

If the Cisco router is in one of the numbered ports of the DIR-655, you should be able to access the setup page via the DIR-655's LAN IP. Do you remember the LAN IP address of the DIR-655?

If the Cisco router is connected to the Internet port of the DIR-655, you should be able to access the setup page via the assigned LAN IP from Cisco to DIR-655.

Title: Re: 655 set to bridge mode, can't remember IP, not sure how to connect
Post by: EddieZ on August 23, 2010, 11:11:31 AM

try typing http://dlinkrouter

Title: Re: 655 set to bridge mode, can't remember IP, not sure how to connect
Post by: rcoloma on August 25, 2010, 11:35:40 AM

im pretty shure i saw a thread by Lycan (moderator) saying bridge mode on DIR-655 was disabled because the many problems it was causing.

Title: Re: 655 set to bridge mode, can't remember IP, not sure how to connect
Post by: EddieZ on August 25, 2010, 02:01:50 PM

I am currently using it in bridge mode :). No issues as far as I can see.

Title: Re: 655 set to bridge mode, can't remember IP, not sure how to connect
Post by: Landsknecht on January 21, 2011, 11:45:56 PM

Quote from: EddieZ on August 25, 2010, 02:01:50 PM

I am currently using it in bridge mode :). No issues as far as I can see.

what is the revision version and firmware of your 655?