D-Link Forums
The Graveyard - Products No Longer Supported => D-Link NetDefend Firewalls => Topic started by: Billabongqc on August 16, 2010, 05:44:16 PM
-
Hi,
When I use Emule, I'm always on LowID. I have a DFL-210 (and DIR-825 for router).
I wanna know the procedure to make for opening ports 4662 for TCP and 4672 for UDP.
thanks!
-
1) Objects > Services
Add services:
TCP service named tcp-4662 with destination 4662, keep source by default
UDP service named udp-4772 with destination 4672, keep source by default
Add service group named emule = tcp-4662 + udp-4672
2) Rules > IP rules
SAT wan/all-nets core/wan_ip emule (SAT: new destination = your local IP)
Allow wan/all-nets core/wan_ip emule
-
Thanks for the answer.
If i have 3 computers with emule, i have to do the SAT setting for each computer?
AND...
For SAT:
--ญญญญญ) GENERAL
Name : I choose the name
Action : SAT
Service : emule = tcp-4662 + udp-4672
Schedule: none
--ญญญญญ) ADRESS FILTER
Source interface : WAN
Source Network : all-net
Destination interface :core
Destination Network : wan_ip
and fot the SAT setting:
Translate the DESTINATION IP
New ip Adress : the ip of my computer
For ALLOW:
--ญญญญญ) GENERAL
Name : I choose the name
Action : Allow
Service : emule = tcp-4662 + udp-4672
Schedule: none
--ญญญญญ) ADRESS FILTER
Source interface : WAN
Source Network : all-net
Destination interface :core
Destination Network : wan_ip
is it that?
-
You should make actions i wrote before 3 times - for every PC with emule. Ports in service should be different, "emule" groups - too.
About rule. wan/all-nets CORE/WAN_IP. In SAT tab, set local PC address.
-
Thanks,
my emule is HighID now :)