• November 30, 2022, 03:12:14 AM
  • Welcome, Guest
Please login or register.

Login with username, password and session length
Advanced search  


This Forum Beta is ONLY for registered owners of D-Link products in the USA for which we have created boards at this time.

Author Topic: Problem with DAP-1360 configuration  (Read 4074 times)

the virus

  • Level 1 Member
  • *
  • Posts: 1
Problem with DAP-1360 configuration
« on: April 22, 2017, 07:20:23 AM »


I want to know how I will configure this DAP-1360 (in which mode) to make this network work . (Attached the image of the network)



  • Poweruser
  •   ▲
    ▲ ▲
  • *****
  • Posts: 49923
  • D-Link Global Forum Moderator
    • Router Troubleshooting
Re: Problem with DAP-1360 configuration
« Reply #1 on: April 22, 2017, 09:12:12 AM »

  • What Hardware version is your DAP? Look at the sticker under the DAP.
  • Link>What Firmware version is currently loaded? Found on the DAPs web page under status.
  • What region are you located?

That would be wireless bridge mode. I don't remember off the top of my head of the 1360 supports wireless bridge mode. You can look at the user manual or walk the setup wizard on the 1360 and see if wireless bridge mode appears, if so, then use the wizard to set up the DAP for this mode.

Cable: 1Gb/50Mb>NetGear CM1200>DIR-882>HP 24pt Gb Switch. COVR-1202/2202/3902,DIR-2660/80,3xDGL-4500s,DIR-LX1870,857,835,827,815,890L,880L,868L,836L,810L,685,657,3x655s,645,628,601,DNR-202L,DNS-345,DCS-933L,936L,960L and 8000LH.