D-Link Forums
The Graveyard - Products No Longer Supported => IP Cameras => DCS-932L => Topic started by: harrydr on July 19, 2017, 06:06:15 AM
-
My dcs-932L does not go to green. changed cables, router all i can imagine. any advice?
-
Was it working before?
Can you access the camera? (mydlink app or web browser)
Is the red light blinking or is it solid?
Try resetting it (paperclip in reset hole for 10 seconds and release). You will have to reconfigure it.
-
Link>Welcome! (http://forums.dlink.com/index.php?topic=48135.0)
- What Hardware version is your DCS? Look at the sticker behind or under the camera.
- Link>What Firmware (http://forums.dlink.com/index.php?topic=47512.0) version is currently loaded? Found on the DCSs web page under status.
- What region are you located?
What Mfr and model is the main host router?
What wireless modes are you using?
What is the distance between the Camera and the main host router?
Place the camera near the router or use LAN cable to connect the camera to the router?
My dcs-932L does not go to green. changed cables, router all i can imagine. any advice?
-
Can't get seeing it to router dir-868l not. did reset and so onhw ver a1 f/w ver 1.01 as not seeing can't aupdaten firmware
-
What region are you located?
Try this, change the 2.4Ghz radio on the 868L for OPEN security temporarily. Change it from WPA2 to OPEN or disabled. Save settings. Factory reset the camera and see if it will reconnect to the 2.4Ghz radio on the 868L. I presume if it won't, then D-Link support will need to be contacted on the phone.