D-Link Forums

The Graveyard - Products No Longer Supported => IP Cameras => DCS-932L => Topic started by: ketchoupi on December 17, 2013, 01:23:36 PM

Title: change status of motion detection via http?
Post by: ketchoupi on December 17, 2013, 01:23:36 PM

hi

i'm using a dcs-932l since one day.
my english isn't very good but i'm tring to explain what i want

i've a question about motion detection :
is it possible to change status of motion detection via http in local network?

ex: http://IPcam:port/set_alarm.cgi?motion_armed=0 &user=user&pwd=password
      http://IPcam:port/set_alarm.cgi?motion_armed=1 &user=user&pwd=password'

thanks for your attention


edit: http://user:pwd:80/config/motion.cgi?enable=yes    not good to .....

Title: Re: change status of motion detection via http?
Post by: ketchoupi on December 21, 2013, 09:42:13 AM

i think it's almost

http://IPADRESS/motion.cgi?user=XXXXXX&password=XXXXXX



MotionDetectionEnable=1
MotionDetectionBlockSet=0000000000000000000000000
MotionDetectionSensitivity=20


someone else want to try?

source :http://www.ispyconnect.com/man.aspx?n=D-Link

Title: Re: change status of motion detection via http?
Post by: josepa2mander on November 17, 2014, 02:28:04 PM

Did you find the answer? I personally search this functionality and didn't find yet for my DCS-933L!