• March 28, 2024, 01:46:37 PM
  • Welcome, Guest
Please login or register.

Login with username, password and session length
Advanced search  

News:

This Forum Beta is ONLY for registered owners of D-Link products in the USA for which we have created boards at this time.

Author Topic: DCS-852L wont turn on  (Read 10388 times)

servis

  • Level 1 Member
  • *
  • Posts: 1
DCS-852L wont turn on
« on: May 11, 2017, 03:21:08 AM »

Hi, I need help with one DCS-852L, camera wont turn on.

When connected to power supply it is pulling 5V 0.30A, and power is reacting on cameras power switch. When connected to UART / TTL nothing is happening. I tried different pinouts and boundrate speeds, but nothing.

Is it possible that the boot loader is corrupted, and if yes, is there any way to repair it?

Regards
Logged

FurryNutz

  • Poweruser
  •   ▲
    ▲ ▲
  • *****
  • Posts: 49923
  • D-Link Global Forum Moderator
    • Router Troubleshooting
Re: DCS-852L wont turn on
« Reply #1 on: May 11, 2017, 10:00:18 AM »

IF this fails, I presume the camera is dead:
Emergency Recovery Mode
Logged
Cable: 1Gb/50Mb>NetGear CM1200>DIR-882>HP 24pt Gb Switch. COVR-1202/2202/3902,DIR-2660/80,3xDGL-4500s,DIR-LX1870,857,835,827,815,890L,880L,868L,836L,810L,685,657,3x655s,645,628,601,DNR-202L,DNS-345,DCS-933L,936L,960L and 8000LH.

JJdaCool

  • Level 1 Member
  • *
  • Posts: 24
  • i
Re: DCS-852L wont turn on
« Reply #2 on: May 19, 2017, 08:56:42 PM »

I don't know if hard wired (usb to computer UART or TTL) communication is possible with this camera.
 Try looking for a wifi wireless connection like DCS_825L_xxxx, the wifi password should be listed on the camera plastic.
(Also you might try a D-link or similar 5v 2 amp usb power supply.)

If wifi works, the IP address would be like
http://10.255.255.1/eng/mainFrame.cgi
 
 (Also if you see an unsecured open wifi network, like RT2860, do not connect to that network.
The camera makes that when first booting up but then changes to the secured DCS_825L_.... ) 

Logged
Yo!