D-Link VPN Router > DSR-1000AC
QOS for VOIP
scoody:
Hi,
I have 4 phones on VOIP their IP are DHCP adresses.
The Dlink is connected 100meg half duplex to a fiber router
My internet access is a fiber link 10meg up and 10meg down
My link 10 meg is regulary 100% used and phone are unusables.
How can i set QOS for preserving the voice quality ? On ports on IP ??
I made : Network / traffic management
then bandwith profil , where i have created a plocicy 'phone out' (outband/prority/dedicated/high)
Thren created services in traffic shapping menu on SIP TCP and SIP UDP protocols
Activated also Bride profiles
But i'm lost ....
Laurent
Thanks for your help
Gattsu:
You can try the following.
-Create a Customer Service-
name: SIP-Both
Source Port Start: 1
Source Port End: 65535
Destination Port Start: 5060
Destination Port End: 5060
Create a Bandwidth Profile-
name: OutboundForSip
Policy Type: outbound
WAN interface: Dedicated WAN
Profile Type: Rate (or Priority)
Min. Band Rate: 1
Max. Band Rate: 2000
-Create a new Traffic Selector-
Available Profile: OutboundForSip
Service: SIP-Both
Traffic Selector Match Type: IP
IP address: 192.168.10.1 (which ever the IP/network of phones)
Subnet Mask: 255.255.255.0
scoody:
great, just when i go in "Bridge Trafic Selectors" , in the dropdown list i have nothing.
Custom service and bandwith profile are created with parameters you gave, no trouble on this part.
I will have to do this 4 times for the 4 phones ?
Gattsu:
Just make sure your DSR-1000AC is updated to the latest firmware version followed by a factory reset. Please try again with a different web-browser.
Yes this should work for all phones using SIP protocol in the network of 192.168.10.X with mask 255.255.255.0. If it was for a single device then it would be set 192.168.10.X with mask 255.255.255.255.
scoody:
Hi,
My firmware is 3.11_WW ,
i created the Bandwidth Profile- in BRIDGE bandwidth instead of bandwidth profile then i was able to select it in dropdown menu .
how can i monitor if it works ?
The Phone quality is still bad.
Thanks for your help .
Laurent
Navigation
[0] Message Index
[#] Next page
Go to full version