D-Link Forums

D-Link IP Cameras for Business => DCS-4622 => Topic started by: allknowingeye on March 18, 2019, 04:52:05 PM

Title: Percentage Option Missing from Motion Detection Setup
Post by: allknowingeye on March 18, 2019, 04:52:05 PM

With the DCS-4622 I purchased I see in the Manual Motion Detection Screen the control for Percentage of Motion filling the screen is completely missing. This is not acceptable. The only control is Sensitivity. This greatly limits the proper operation of this camera. I notice that almost all the motion detections are late.

When will this be corrected? I want to buy more but I need to how to control this.

The bizzare thing is if you look at the system log when you change the sensitivity percentage it says:
1. 2019/03/18 17:50:10 admin from 192.168.1.240 set motion detection sensitivity from 92 to 90.
2. 2019/03/18 17:50:10 admin from 192.168.1.240 set motion detection percentage from 8% to 10%.

These controls should be completely independent as they are on every other DCS Series Camera.

Title: Re: Percentage Option Missing from Motion Detection Setup
Post by: Anthonyo60 on July 07, 2020, 03:11:00 AM

Hello
Did you have answer ?
I have 2 camera, with same problem

Title: Re: Percentage Option Missing from Motion Detection Setup
Post by: FurryNutz on July 07, 2020, 10:54:04 AM

Link>Welcome! (http://forums.dlink.com/index.php?topic=49573.0)

• What Hardware version is your DCS? Look at the sticker behind or under the camera.
• Link>What Firmware (http://forums.dlink.com/index.php?topic=47512.0) version is currently loaded? Found on the DCSs web page under status.
• What region are you located?

What browser are you using?
Please provide a screen capture of what your seeing.
- Adding Screenshots In A Post (http://forums.dlink.com/index.php?topic=58120.0)