• April 11, 2021, 04:00:01 PM
  • Welcome, Guest
Please login or register.

Login with username, password and session length
Advanced search  


This Forum Beta is ONLY for registered owners of D-Link products in the USA for which we have created boards at this time.

Author Topic: re-connect after power lost?  (Read 3168 times)


  • Level 1 Member
  • *
  • Posts: 2
re-connect after power lost?
« on: July 12, 2017, 04:41:26 AM »

I have a D-Link DCS-2530L FHD 180 , after a power loss of 1H the camera does not re-connect to the wlan, unless someone climbs up the wall and presses the button at the rear. If pressed, the camera finds the wlan and logs in again.

Any chance that the camra does that on it's own?  ;D



  • Poweruser
  •   ▲
    ▲ ▲
  • *****
  • Posts: 49570
  • D-Link Global Forum Moderator
    • Router Troubleshooting
Re: re-connect after power lost?
« Reply #1 on: July 12, 2017, 10:25:18 AM »

What region are you located?
What FW is currently loaded on the camera?

What Mfr and Model# is the main host wireless router?
What wireless modes are you using?
If you disconnect the cameras power for 5 minutes, then power back on the camera, does the same thing happen?
Set a static IP address ON the camera and see if the same thing happens. 192.168.#.25
Is uPnP and uPnP Port Forwarding enabled on the camera?
Cable: 1Gb/50Mb>NetGear CAX80>DIR-882>HP 24pt Gb Switch. COVR-1202/2202/3902,DIR-2660/80,3xDGL-4500s,DIR-857,835,827,815,890L,880L,868L,836L,810L,685,657,3x655s,645,628,601,DNR-202L,DNS-345,DCS-933L,936L,960L and 8000LH.