Topic: Could dlink make a new firmware to add ipv6 pass-through ability for the router? (Read 10503 times)

LynnField1366 · « **on:** March 07, 2017, 10:58:16 AM »

only in this way i can get the access to ipv6...

FurryNutz · « **Reply #1 on:** March 07, 2017, 12:50:31 PM »

What Hardware version is your router? Look at sticker under the router case.
Link>What Firmware version is currently loaded? Found on the routers web page under status.
What region are you located?

How do you have the router configured? There is a a drop down for Automatic and Local Only. I think if you use local only with out any other configurations, IPv6 should pass thru. Not sure however.

FYI:
This product has been discontinued.
Free support for this product will end on 05/01/2018

If you can't seem to get the 855 to work, you might try some DD-WRT or OpenWRT to see if they support this model router....

You can use this as as LAN to LAN AP then anything will pass-thru: Turning a router into an AP.

FurryNutz · « **Reply #2 on:** March 15, 2017, 11:38:31 AM »

Any status on this?

Quote from: LynnField1366 on March 07, 2017, 10:58:16 AM

only in this way i can get the access to ipv6...

D-Link Forums

News:

Author Topic: Could dlink make a new firmware to add ipv6 pass-through ability for the router? (Read 10503 times)

LynnField1366

Could dlink make a new firmware to add ipv6 pass-through ability for the router?

FurryNutz

Re: Could dlink make a new firmware to add ipv6 pass-through ability for the router?

FurryNutz

Re: Could dlink make a new firmware to add ipv6 pass-through ability for the router?