• December 06, 2021, 06:17:55 AM
  • Welcome, Guest
Please login or register.

Login with username, password and session length
Advanced search  


This Forum Beta is ONLY for registered owners of D-Link products in the USA for which we have created boards at this time.

Author Topic: Can't connect to 5ghz and 2.4ghz is terrible  (Read 2844 times)


  • Level 1 Member
  • *
  • Posts: 1
Can't connect to 5ghz and 2.4ghz is terrible
« on: September 01, 2020, 03:37:16 PM »

When I try to search my 5ghz wifi on the repeater dap1530 configutation pag ( to have a decent wireless internet going from my router to the repeater itself, it only shows the 2.4ghz SSID, so much for a dual band repeter, its more like a single band receiver and dual band transmiter, even if I manually write the 5ghz SSID on the web configuration page ( it does not work... It can only use the 2.4ghz to receive internet data.
And BTW, on the 2.4ghz it is terrible, even if I use the repeater right next the my router, like touching it, it only gets 20mb of my 250mb internet speed, so it is only usefull as a wired access point.
« Last Edit: September 01, 2020, 04:17:03 PM by PistolaoBR »


  • Poweruser
  •   ▲
    ▲ ▲
  • *****
  • Posts: 49865
  • D-Link Global Forum Moderator
    • Router Troubleshooting
Re: Can't connect to 5ghz and 2.4ghz is terrible
« Reply #1 on: September 15, 2020, 07:47:12 AM »

Had the DAPs FW been updated?
Factory rest the DAP and setup from scratch?
What is the Mfr and model# of the host router the DAP is connected too?
Cable: 1Gb/50Mb>NetGear CM1200>DIR-882>HP 24pt Gb Switch. COVR-1202/2202/3902,DIR-2660/80,3xDGL-4500s,DIR-LX1870,857,835,827,815,890L,880L,868L,836L,810L,685,657,3x655s,645,628,601,DNR-202L,DNS-345,DCS-933L,936L,960L and 8000LH.