• January 23, 2022, 12:55:03 AM
  • Welcome, Guest
Please login or register.

Login with username, password and session length
Advanced search  


This Forum Beta is ONLY for registered owners of D-Link products in the USA for which we have created boards at this time.

Author Topic: Setting up Mesh with the DAP‑1620  (Read 3544 times)


  • Level 1 Member
  • *
  • Posts: 1
Setting up Mesh with the DAP‑1620
« on: June 13, 2020, 11:46:05 AM »


I am unable to setup a mesh with the DAP-1620 extensions.

I own the `DIR-1960 HW:A1 FW:1.03`

and 2: `DAP-1620 HW:A2 FW:1.05`

When going through the whole setup on the wifi iOS app I get the error:

Sync up failed

And then an error message telling me to reset. Which I have tried multiple times on both of the DAP-1620 with no luck!

What is going on? Any tips. I know that the router accepts the DAP-1620 as it gets very far along with the steps I am not sure what is wrong with the last step. I have tried multiple ethernet cables too!



  • Poweruser
  •   ▲
    ▲ ▲
  • *****
  • Posts: 49884
  • D-Link Global Forum Moderator
    • Router Troubleshooting
Re: Setting up Mesh with the DAP‑1620
« Reply #1 on: June 16, 2020, 01:11:13 PM »

Any progress on this?
Cable: 1Gb/50Mb>NetGear CM1200>DIR-882>HP 24pt Gb Switch. COVR-1202/2202/3902,DIR-2660/80,3xDGL-4500s,DIR-LX1870,857,835,827,815,890L,880L,868L,836L,810L,685,657,3x655s,645,628,601,DNR-202L,DNS-345,DCS-933L,936L,960L and 8000LH.


  • Technical Engineer
  • Level 1 Member
  • *
  • Posts: 2
Re: Setting up Mesh with the DAP‑1620
« Reply #2 on: October 19, 2020, 09:55:43 AM »

Factory reset DAP-1620 and then use the  Manual Configuration (Web UI) option to setup the extender with DIR-1960: