• November 28, 2021, 03:43:31 AM
  • Welcome, Guest
Please login or register.

Login with username, password and session length
Advanced search  

News:

This Forum Beta is ONLY for registered owners of D-Link products in the USA for which we have created boards at this time.

Author Topic: Dir-600 b2e - only red power light  (Read 5681 times)

milika

  • Level 1 Member
  • *
  • Posts: 3
Dir-600 b2e - only red power light
« on: November 15, 2018, 03:35:26 PM »

Hi,
router was working fine, and then one day it lost all the light, just power was solid orange.
Tried reset, holding reset to do emergency firmware update, nothing helped.
Power Light  always stayed orange, no other lights even blinked once...

Any help?

Thanks
Logged

FurryNutz

  • Poweruser
  •   ▲
    ▲ ▲
  • *****
  • Posts: 49863
  • D-Link Global Forum Moderator
    • Router Troubleshooting
Re: Dir-600 b2e - only red power light
« Reply #1 on: November 15, 2018, 03:55:40 PM »

Link>Welcome!

  • What Hardware version is your router? Look at sticker under the router case.
  • Link>What Firmware version is currently loaded? Found on the routers web page under status.
  • What region are you located?

Check the power adapter tip for voltage and amps. If good here, possible router is dead.
I recommend that you phone contact your regional D-Link support office and ask for help and information regarding this.
Link> Tech Support Contact Information
We find that phone contact has better immediate results over using email.
Logged
Cable: 1Gb/50Mb>NetGear CM1200>DIR-882>HP 24pt Gb Switch. COVR-1202/2202/3902,DIR-2660/80,3xDGL-4500s,DIR-LX1870,857,835,827,815,890L,880L,868L,836L,810L,685,657,3x655s,645,628,601,DNR-202L,DNS-345,DCS-933L,936L,960L and 8000LH.

milika

  • Level 1 Member
  • *
  • Posts: 3
Re: Dir-600 b2e - only red power light
« Reply #2 on: November 15, 2018, 03:57:29 PM »

H/W ver:B2 F/W ver: 2.03
Voltages are ok, i tried with different adapter, it draws 0.4a steady...

Regards!
Logged

FurryNutz

  • Poweruser
  •   ▲
    ▲ ▲
  • *****
  • Posts: 49863
  • D-Link Global Forum Moderator
    • Router Troubleshooting
Re: Dir-600 b2e - only red power light
« Reply #3 on: November 15, 2018, 03:59:25 PM »

You can try this:
Emergency Recovery Mode

If this fails, then you'll need to find a new router.
Logged
Cable: 1Gb/50Mb>NetGear CM1200>DIR-882>HP 24pt Gb Switch. COVR-1202/2202/3902,DIR-2660/80,3xDGL-4500s,DIR-LX1870,857,835,827,815,890L,880L,868L,836L,810L,685,657,3x655s,645,628,601,DNR-202L,DNS-345,DCS-933L,936L,960L and 8000LH.

milika

  • Level 1 Member
  • *
  • Posts: 3
Re: Dir-600 b2e - only red power light
« Reply #4 on: November 15, 2018, 04:01:57 PM »

Thanks, but tried, light never blinks. Only stays orange.
Nevertheless i tried with static ip in 192.168.0.0 and 192.168.1.0 range - could not access 192.168.0.1/192.168.1.1 respectively.

Tried tft flashing also - never even started :)
Logged

FurryNutz

  • Poweruser
  •   ▲
    ▲ ▲
  • *****
  • Posts: 49863
  • D-Link Global Forum Moderator
    • Router Troubleshooting
Re: Dir-600 b2e - only red power light
« Reply #5 on: November 16, 2018, 07:16:23 AM »

I think you need a new router.  :-\
Logged
Cable: 1Gb/50Mb>NetGear CM1200>DIR-882>HP 24pt Gb Switch. COVR-1202/2202/3902,DIR-2660/80,3xDGL-4500s,DIR-LX1870,857,835,827,815,890L,880L,868L,836L,810L,685,657,3x655s,645,628,601,DNR-202L,DNS-345,DCS-933L,936L,960L and 8000LH.