• March 28, 2024, 09:52:09 AM
  • Welcome, Guest
Please login or register.

Login with username, password and session length
Advanced search  

News:

This Forum Beta is ONLY for registered owners of D-Link products in the USA for which we have created boards at this time.

Author Topic: IPv6 Support  (Read 8648 times)

drshock

  • Level 2 Member
  • **
  • Posts: 52
IPv6 Support
« on: September 13, 2015, 08:10:39 AM »

I have a DAP-1522 rev A1 with last firmware available installed, 1.42.    I did not replace it when switching over to IPv6 because this D-Link list at the bottom Q&A states it supports IPv6 - http://us.dlink.com/technology/dlink-ipv6-solutions/

I noticed I do not see the IPv6 configuration options in my firmware UI that are shown starting on page 24 here either - http://www.dlink.com/-/media/Consumer_Products/DAP/DAP%201522/Manual/DAP%201522_Manual_EN_US.pdf

Is it possible that only the rev B hardware supports IPv6 and not the A rev?  If so, this should be clarified at the D-Link USA support site.
Logged
Live for today....

FurryNutz

  • Poweruser
  •   ▲
    ▲ ▲
  • *****
  • Posts: 49923
  • D-Link Global Forum Moderator
    • Router Troubleshooting
Re: IPv6 Support
« Reply #1 on: September 13, 2015, 10:49:43 AM »

The DAP-1522 is based on similar HW as the DIR-655 Rev A. Both were succeeded with Rev B versions as well and I know that Rev B 655 supported IPv6. Rev A did not and I presume that Rev A DAP-1522 is the same. Most Rev A models of that time frame did not support IPv6.
Logged
Cable: 1Gb/50Mb>NetGear CM1200>DIR-882>HP 24pt Gb Switch. COVR-1202/2202/3902,DIR-2660/80,3xDGL-4500s,DIR-LX1870,857,835,827,815,890L,880L,868L,836L,810L,685,657,3x655s,645,628,601,DNR-202L,DNS-345,DCS-933L,936L,960L and 8000LH.