D-Link Forums

The Graveyard - Products No Longer Supported => Hubs and Switches => DGS-1216T => Topic started by: teclim on November 02, 2016, 07:04:11 AM

Title: dgs 12-10 configure acl
Post by: teclim on November 02, 2016, 07:04:11 AM
Hello,
I use a dgs-1210 with the lastest firmware and I would like to block all the UDP trafic on the 12 port. So I create a profile in the acl section with this settings
For the Profile
PROTOCOLE IP : UDP
source Port : FFFF
Destination Port : FFFF

and for th rule :
access ID : 2
Source Port and Destination Port : Empty
Ports : 12
Action : Deny

But Unfortunately it doesn't work ?
Do you know why ? And what must I do ?
Thanks.
Title: Re: dgs 12-10 configure acl
Post by: FurryNutz on November 02, 2016, 07:13:17 AM
Link>Welcome! (http://forums.dlink.com/index.php?topic=48135.0)


Is there any information in the user manual on how to configure the DGS for this feature?
Title: Re: dgs 12-10 configure acl
Post by: teclim on November 02, 2016, 07:56:45 AM
I'm located in France .
I already read the manual to page 78 but it's not working so I'm wrong.
Title: Re: dgs 12-10 configure acl
Post by: FurryNutz on November 15, 2016, 01:47:40 PM
Did you get any progress on this?  ???
Title: Re: dgs 12-10 configure acl
Post by: teclim on November 17, 2016, 02:09:02 AM
Thanks for your interessed of my problem.
I solve my problem with an other way, I activate the igmp to filter the trafic.
Title: Re: dgs 12-10 configure acl
Post by: FurryNutz on November 17, 2016, 07:09:12 AM
Glad you were able to figure it out. Thanks for letting us know. Hope it helps future users.  ;)