D-Link Forums
The Graveyard - Products No Longer Supported => Routers / COVR => DIR-600 => Topic started by: Javieradriano10 on May 24, 2016, 04:28:58 AM
-
Hi there! I'm new so please bare with me. I have a PLDT Fibr modem, I can configure it by going to the ip address 192.168.1.1 via my computer, it is connected a Tenda router that I can configure by going to the ip address 192.168.2.1, later or, I connected a Dlink DIR-600 to the tenda and connected my laptop to the DIR-600, however, I do not know how to configure this router, I tried going to 192.168.3.1, 192.168.1.2, 192.168.2.2, and cannot find the configuration page of the DLink router. What I am trying to do with this router is change the password and SSID, however, I am unable to since I can't find its IP Adress/Gateway to configure it. Any suggestions? I'll take any.
-
Link>Welcome! (http://forums.dlink.com/index.php?topic=48135.0)
- What Hardware version is your router? Look at sticker under the router case.
- Link>What Firmware (http://forums.dlink.com/index.php?topic=47512.0) version is currently loaded? Found on the routers web page under status.
- What region are you located?
I recommend if you already have additional routers, that you set up the 600 as a wired AP: Turning a router into an AP. (http://forums.dlink.com/index.php?topic=40856.0)
D-Link routers have an default IP address of 192.168.0.1. You'll need to change this to something that doesn't conflict with your current IP address configuration. Try 192.168.1.60 for the DIR-600. Then set up as a wired AP.