D-Link Forums

The Graveyard - Products No Longer Supported => Routers / COVR => DIR-605L => Topic started by: Mattred on August 31, 2015, 08:46:23 PM

Title: How can i use the DIR-605L as a wifi "extender"
Post by: Mattred on August 31, 2015, 08:46:23 PM

I have set the router to the "WDP+AP" setting and used the MAC address of the original router in the bridge settings. I've also disabled DCHP and UPNP however it still displays no internet access. What can i do from here to get it working?

Title: Re: How can i use the DIR-605L as a wifi "extender"
Post by: FurryNutz on September 01, 2015, 07:24:10 AM

Link>Welcome! (http://forums.dlink.com/index.php?topic=48135.0)

• What Hardware version is your router? Look at sticker under the router case.
• Link>What Firmware (http://forums.dlink.com/index.php?topic=47512.0) version is currently loaded? Found on the routers web page under status.
• What region are you located?

Internet Service Provider and Modem Configurations

• What ISP Service do you have? Cable or DSL?
• What ISP Modem Mfr. and model # do you have?

What Mfr and model is thee main host router?


Try this? http://forums.dlink.com/index.php?topic=52818.0 (http://forums.dlink.com/index.php?topic=52818.0)

Title: Re: How can i use the DIR-605L as a wifi "extender"
Post by: FurryNutz on September 03, 2015, 07:09:31 AM

Any status on this?  ???

Quote from: Mattred on August 31, 2015, 08:46:23 PM

I have set the router to the "WDP+AP" setting and used the MAC address of the original router in the bridge settings. I've also disabled DCHP and UPNP however it still displays no internet access. What can i do from here to get it working?