• July 02, 2022, 08:32:46 PM
  • Welcome, Guest
Please login or register.

Login with username, password and session length
Advanced search  


This Forum Beta is ONLY for registered owners of D-Link products in the USA for which we have created boards at this time.

Author Topic: Console Message "enable hardware natting for forwarding acceleration"  (Read 6092 times)


  • Level 1 Member
  • *
  • Posts: 21

I see this message on my Serial Console just after the system reboots, I can't find any documentation, any Idea on where how I enable this, or is it just a bogus message?

Enable hardware natting for forwarding acceleration

DSR-250 login:


  • Poweruser
  •   ▲
    ▲ ▲
  • *****
  • Posts: 49916
  • D-Link Global Forum Moderator
    • Router Troubleshooting
Re: Console Message "enable hardware natting for forwarding acceleration"
« Reply #1 on: September 13, 2012, 07:01:17 AM »

I would ask DLink. Might be some intermittent diagnostic message that should not be there.
Cable: 1Gb/50Mb>NetGear CM1200>DIR-882>HP 24pt Gb Switch. COVR-1202/2202/3902,DIR-2660/80,3xDGL-4500s,DIR-LX1870,857,835,827,815,890L,880L,868L,836L,810L,685,657,3x655s,645,628,601,DNR-202L,DNS-345,DCS-933L,936L,960L and 8000LH.