D-Link Forums
The Graveyard - Products No Longer Supported => Routers / COVR => DIR-867 => Topic started by: SteveM on April 15, 2019, 12:41:00 PM
-
Hi,
I had a router with DD-WRT firmware running ahead of our Windows VPN server. I just swapped it out for a DIR-865 and now I can't get the tunnel working. My current settings:
Connection: Dynamic IP (DHCP) (I have Cox cable)
Subnet Mask 255.255.255.0
Enable DNS Relay: (tried both on and off)
DHCP Server: on
I have Virtual Servers and Port Forwarding set up to forward 1723 and 47 to the Server's IP address 192.168.1.111
I disabled SPI
Set NAT endpoint filtering to Independent
Currently I have checked all ALG options. I started with IPSec (VPN) unchecked.
I enabled WAN Ping Response for troubleshooting
I can ping the external IP address successfully, but when I try to connect it says:
Connecting to VPN (briefly)
Verifying your sign-in info...
Then hang for a while, and tries again.
Finally I get an error saying "Can't connect to <VPN>. The remote connection was not made because the attempted VPN tunnels failed. The VPN server might be unreachable. If this connection is attempting to use an L2TP/IPsec tunnel, teh security parameters required for IPsec negotiation might not be configured properly.
Any hints on how to troubleshoot, or what setting I might have wrong?
Thanks!
-
Link>Welcome! (http://forums.dlink.com/index.php?topic=49573.0)
- What Hardware version is your router? Look at sticker under the router case.
- Link>What Firmware (http://forums.dlink.com/index.php?topic=47512.0) version is currently loaded? Found on the routers web page under status.
- What region are you located?
DIR-865L or 867?
Internet Service Provider and Modem Configurations
- What ISP Service do you have? Cable or DSL?
- What ISP Modem Mfr. and model # do you have?