• March 28, 2024, 10:29:32 PM
  • Welcome, Guest
Please login or register.

Login with username, password and session length
Advanced search  

News:

This Forum Beta is ONLY for registered owners of D-Link products in the USA for which we have created boards at this time.

Author Topic: VLAN Not seperate  (Read 5294 times)

Techie999

  • Level 1 Member
  • *
  • Posts: 1
VLAN Not seperate
« on: September 13, 2017, 10:43:09 PM »

Hi all,

I've got 3 1510's that i want to set up with a VLAN across them to seperate a WAN connection from so i've set up a VLAN100 (via the cli as the GUI doesn't seem to work that well) and was expecting this VLAN to be inaccessible from the native VLAN but it is i.e if i plug a device in the VLAN ports and another device in the native VLAN then i can ping both devices ? what i want is for it to act essentially like a seperate switch that data cannot get in our out of that VLAN ?
Can anyone tell me where i'm going wrong ?

Thanks
Logged

FurryNutz

  • Poweruser
  •   ▲
    ▲ ▲
  • *****
  • Posts: 49923
  • D-Link Global Forum Moderator
    • Router Troubleshooting
Re: VLAN Not seperate
« Reply #1 on: September 14, 2017, 08:12:00 AM »

Link>Welcome!

  • What region are you located?

Any information in the user manuals regarding this?
Logged
Cable: 1Gb/50Mb>NetGear CM1200>DIR-882>HP 24pt Gb Switch. COVR-1202/2202/3902,DIR-2660/80,3xDGL-4500s,DIR-LX1870,857,835,827,815,890L,880L,868L,836L,810L,685,657,3x655s,645,628,601,DNR-202L,DNS-345,DCS-933L,936L,960L and 8000LH.

PacketTracer

  • Level 4 Member
  • ****
  • Posts: 441
Re: VLAN Not seperate
« Reply #2 on: September 14, 2017, 03:32:25 PM »

Hi,

I found this configuration example, which explains the VLAN settings either using the GUI or the CLI. Maybe this helps you solve your problem. Of course, the best source of wisdom is the CLI reference guide (Chapter 75 starting at page 669).

I'm not sure what you mean, when you say "if i plug ... another device in the native VLAN". But anyway you obviously plugged two devices to ports with different VLAN settings. Could you show the port settings of these two ports, as shown in the CLI via "show vlan interface ethx/0/y"? Similarly, in case the three switches are not stacked, how are they interconnected to each other, and what do the port configurations (again "show vlan interface eth0/x") of the interconnection ports look like?

PT
« Last Edit: September 17, 2017, 12:08:04 PM by PacketTracer »
Logged