The Graveyard - Products No Longer Supported > DIR-890L
Fios setup help
Mkstretch:
I have setup a few access points to work with Verizon's actiontec router. But this Dlink AC3200 doesn't make it easy. Can anyone point me to the correct settings. Thx
FurryNutz:
Is the ISP ONT bridged?
Checj ur lan cables. Use cat6,
Mkstretch:
I had an asus ac66u connected to my fios router as an AP and didn't change the fios router to anything else. What needs to be don't to bridge it? I have the dlink connected lan to lan on fios router.
FurryNutz:
Do you still want to use the 890L as an AP only or as a main host router?
If you want main host router, then you'll need to have your ISP bridge the ONT service and connect the WAN port on the 890L to the ISP ONT.
If you want the 890L just as an AP, then you'll need to set AP mode on the 890L, then connect LAN to LAN to the ISP ONT. Then look on the ONTs DHCP IP address table list for the IP address it gives the 890L to access it's UI while in AP mode.
Mkstretch:
Yes I would like to keep it as an AP. Where is the setting for AP mode?
Navigation
[0] Message Index
[#] Next page
Go to full version