• December 08, 2021, 02:54:49 AM
  • Welcome, Guest
Please login or register.

Login with username, password and session length
Advanced search  

News:

This Forum Beta is ONLY for registered owners of D-Link products in the USA for which we have created boards at this time.

Author Topic: Can't recover to original firmware  (Read 4396 times)

pcking

  • Level 1 Member
  • *
  • Posts: 1
Can't recover to original firmware
« on: October 16, 2018, 11:35:06 AM »

Hi. I am struggling to recover my D-Link DIR-632. I have tested DD-WRT on it but now I want to go back. WIFI won't turn on and I cannot access the web interface after restore. In the Emergency Recovery site it will only say Flashing.. but never says Success. Any tips? FYI I live in Norway and broth this router for eBay since I originally wanted DD-WRT on but are facing some issues with it.
Best regards
pcking

Firmware is downloaded from D-Link support site 1.03(ftp://ftp2.dlink.com/PRODUCTS/DIR-632/REVA/DIR-632_FIRMWARE_1.03.ZIP)
Logged

FurryNutz

  • Poweruser
  •   ▲
    ▲ ▲
  • *****
  • Posts: 49868
  • D-Link Global Forum Moderator
    • Router Troubleshooting
Re: Can't recover to original firmware
« Reply #1 on: October 16, 2018, 12:08:25 PM »

Link>Welcome!

  • What region are you located?

Review this:
Emergency Recovery Mode

If this fails, then the router maybe bad...
Logged
Cable: 1Gb/50Mb>NetGear CM1200>DIR-882>HP 24pt Gb Switch. COVR-1202/2202/3902,DIR-2660/80,3xDGL-4500s,DIR-LX1870,857,835,827,815,890L,880L,868L,836L,810L,685,657,3x655s,645,628,601,DNR-202L,DNS-345,DCS-933L,936L,960L and 8000LH.