• April 23, 2024, 10:50:13 AM
  • Welcome, Guest
Please login or register.

Login with username, password and session length
Advanced search  

News:

This Forum Beta is ONLY for registered owners of D-Link products in the USA for which we have created boards at this time.

Author Topic: 1.32NA Build 09 bricked my DIR-655  (Read 5586 times)

lcleeton

  • Guest
1.32NA Build 09 bricked my DIR-655
« on: November 17, 2009, 11:37:31 AM »
Since I've been having to power cycle the unit every few days with 1.32NA, I decided to try the new beta.

I followed this process with my DIR-655 running 1.32NA (released, not beta):
1. reset to factory
2. waited for web interface to respond
3. power cycle
4. updated firmware to build 09
5. waited for web interface to respond
6. reset to factory
7. waited for web interface to respond
8. configured some network settings and "saved"
9. unit no longer responds

I've power cycled now many times.   I've tried resetting to factory after power on.  The unit powers on, flashes the LEDs and then only the power LED remains on.  The switch ports will negotiate and get link but no DHCP.

This unit is out of warranty.   Is there anything I can do now?


Logged

EddieZ

  • Level 10 Member
  • *****
  • Posts: 2494
Re: 1.32NA Build 09 bricked my DIR-655
« Reply #1 on: November 17, 2009, 02:22:59 PM »
Did you try the reset button on the back?
Logged
DIR-655 H/W: A2 FW: 1.33

lcleeton

  • Guest
Re: 1.32NA Build 09 bricked my DIR-655
« Reply #2 on: November 17, 2009, 02:25:32 PM »
Yes.   That's how I did "reset to factory" in the steps I described.   
Logged

KevTech

  • Guest
Re: 1.32NA Build 09 bricked my DIR-655
« Reply #3 on: November 20, 2009, 11:25:50 AM »
Flashed over wired connection?

There was no reason to powercycle after resetting to defaults as this is basically the same thing.

Router may have been not completely ready when you flashed.

If you can get into the interface I would flash again.
Logged