Hi there,
I've been using a couple DCS-930L cams for a few years without issue. Recently, I've lost the ability to connect wirelessly & I don't recall making any changes to my wireless config. Here's my setup:
-linksys e4200 with WPA with a 10 digit passcode. Mixed mode 2.4ghz.
-2 DCS 930L cams with the latest firmware (1.08)
I have attempted to connect with the setup software and make it through the "disconnect Ethernet cable". The cam light remains red.
I have gone in through the manual setup (using the IP address) and have validated the setup is correct.
I have attempted to connect using the wifi protected setup. I actually get a green light for a couple seconds, but when the router stops flashing in wifi setup mode, the cam status light goes back to red.
Any thoughts as to what I'm doing wrong?
Thanks!