• April 19, 2024, 12:59:21 AM
  • Welcome, Guest
Please login or register.

Login with username, password and session length
Advanced search  

News:

This Forum Beta is ONLY for registered owners of D-Link products in the USA for which we have created boards at this time.

Author Topic: IP Address Changed After Powerup  (Read 2740 times)

wjburl

  • Level 1 Member
  • *
  • Posts: 10
IP Address Changed After Powerup
« on: June 05, 2012, 05:55:21 AM »
I have two DCS-932L cameras.  One time on each camera, the IP address changed when I unplugged it to move it to another location.  It doesn't happen all the time.   I have to go through the installation procedure again to determine the new address.
Logged

wjburl

  • Level 1 Member
  • *
  • Posts: 10
Re: IP Address Changed After Powerup
« Reply #1 on: June 05, 2012, 10:44:52 AM »
bimo,  Thanks for the help.  I made the changes.  I hope I did them correctly.  The software sees the camera at the addresses using.  xxx.xxx.xxx.5 and xxx.xxx.xxx.6, except mydlink.com says the cameras are offline.
Logged

wjburl

  • Level 1 Member
  • *
  • Posts: 10
Re: IP Address Changed After Powerup
« Reply #2 on: June 05, 2012, 11:53:31 AM »
I did all reboots suggested, but it didn't work.  I finally use the installation disk and ran through setup wizard again, but keeping the changes I had made earlier.  At the end, there is a mydlink setup.  I used my existing account and now all is working.
Logged