The Graveyard - Products No Longer Supported > DNS-320
DNS-320 Rev A - Firmware v2.05 Build 10 Security Patch Comments & Observations
ftxhifi:
thanks for your feedback, but if i disable smb v1 protocol support on my windows client, i don't have any chance to access my shares..
so it seams to be only smb v1 protocol enabled on samba server on DNS-320.
Do you have an idea how i can configure smb v2 permanently?
i mean the firmware is on flash and i think readonly so if i modify smb.conf, after reboot its set back to default?
perhaps i am not shure if samba 3.5.15 does support smb v2, i read about 3.6 does support this ..
ftxhifi:
Hi there,
i ve found an solution by myself.
I install fonz fun plug 0.7 (ffp) and optware, the i install via ipkg the pkg samba 3.6 (3.6.23).
Then i disabled the original samba server in dlink firmware on /etc/NAS_CFG/config.xml .
I copied the existing smb.conf to optware/etc/samba and then edit the smb.conf.
I add to global-section "min protocol = SMB2" + "max protocol = SMB2" .
restart nmbd and smbd and then it works for me.
greetings ftx
GreenBay42:
Thanks for the update. Glad it is working for you.
bulek:
Hi ftx!
How can i disabled the original smb server? try, but not works.
Please write a step by step guide!
in ffp only available mijzelf:samba-3.6.6.
Thanks!
--- Quote from: ftx on October 13, 2017, 04:40:55 AM ---Hi there,
i ve found an solution by myself.
I install fonz fun plug 0.7 (ffp) and optware, the i install via ipkg the pkg samba 3.6 (3.6.23).
Then i disabled the original samba server in dlink firmware on /etc/NAS_CFG/config.xml .
I copied the existing smb.conf to optware/etc/samba and then edit the smb.conf.
I add to global-section "min protocol = SMB2" + "max protocol = SMB2" .
restart nmbd and smbd and then it works for me.
greetings ftx
--- End quote ---
FurryNutz:
FYI:
Link>D-Link NAS Owner's :: Regarding CripTor Ransomware
Navigation
[0] Message Index
[*] Previous page
Go to full version