The Graveyard - Products No Longer Supported > DCS-935L

No motion detection

(1/2) > >>

raduci:
My camera does not detect any motion, sensitivity set to 100%. Any suggestions ?
Thank you !

FurryNutz:
Link>Welcome!


* What Hardware version is your DCS? Look at the sticker behind or under the camera.
* Link>What Firmware version is currently loaded? Found on the DCSs web page under status.
* What region are you located?

raduci:
Hi !
Thank you very much for your support !
HW version A1, firmware 1.09. I am trying to send capture to a local FTP set on my router. Test image is uploaded successfully, but that's all. I have tried to enable sound detection too, but with no result.
I am located in Romania.

raduci:
If I may add something: I have now set the camera to send image(s) via email when a motion is detected and this works. So, should I have some special settings on the ftp server ? Since it's local I have allowed everybody r/w rights. Access the ftp from a computer works with no problem.

RYAT3:
What special settings are you talking about?

You should be able to set up anonymous ftp.

page 34.

http://www.dlink.com/gr/el/-/media/consumer_products/dcs/dcs-935l/manual/dcs_935l_a1_manual_v1_03_eu.pdf

Navigation

[0] Message Index

[#] Next page