D-Link Forums
The Graveyard - Products No Longer Supported => IP Cameras => DCS-5010L => Topic started by: JavaLawyer on September 12, 2013, 05:08:32 AM
-
DCS-5010L Cumulative Firmware Release Notes
Firmware: 1.06b01 - Date: 2/6/2015
- [New Feature] New mydlink agent 2.0.18-b66
- [Bug Fix] Fixed issue where device would not respond properly to portal commands under relay mode
Firmware: 1.05b08 - Date: 01/29/2015
- [New Feature] New mydlink agent 2.0.18-b62
- [New Feature] Remove SSL, change to support TLS
Firmware: 1.04b17 - Date: 01/09/2015
- [New Feature] Support DIRECT mode
- [New Feature] Add support mydlink Home
- [New Feature] New mydlink agent v2.0.18-b30
- [New Feature] Remove DDNS “DynDns (Free)” and “(Custom)”.
- [New Feature] Clears Dlink15Register flag to 0 when factory reset
- [Bug Fix] Fixed e-mail interval issue on motion/sound detection mode
- [Bug Fix] Fixed CGI stream_info.cgi issue
- [Bug Fix] Fixed bad mjpeg frame issue
- [Bug Fix] Fixed CGI notify_stream.cgi issue (disable motion/sound detection when move P/T)
- [Bug Fix] Fixed day light saving issue (cross year case)
- [Bug Fix] Fixed e-mail sometimes not send issue
- [Bug Fix] Fixed DDNS issue (incorrect password case)
- [Bug Fix] Fixed NTP issue under PPPoE mode
- [Bug Fix] Fixed ICR/IR issue on night when set as “Always Day Mode”
- [Bug Fix] Fixed FTP issue if FTP session is disconnected unexpectedly
- [Known Error] If device is already registered to mydlink, the wizard then always showed timeout and couldn't finish setup, even though the setup succeeds
Firmware: 1.03b08 - Date: 01/22/2014
- [New Feature] New mydlink agent 2.0.17-b40
- [New Feature] Change the default FTP to passive mode
- [New Feature] Support Win8.1 + IE11
- [New Feature] Change WPS led on 10 seconds after WPS succeed
- [New Feature] Change LANDAP protocol’s password length to 0 – 32 characters
- [New Feature] Support Java 7 Update 51
- [New Feature] SSL Certificate will be automatically self signed (regenerated) during initial configuration/factory reset
- [Bug Fix] Adjust sensor settings for sometimes video flash issue
- [Bug Fix] Fixed sometimes incorrect ICR control
- [Bug Fix] Fixed Lens move left/right/up/down incorrect from mydlink portal/app when mirror/flip is enabled
- [Bug Fix] Fixed sometimes bad frame issue
- [Bug Fix] Fixed mydlink event (sound detection) timing issue
Firmware: 1.02b05 - Date: 09/25/2013
- [New Feature] Update mydlink agent to v2.0.17-b28
- [New Feature] Add user can configure interval setting for motion/sound detection of mail/ftp
- [Bug Fix] Fixed schedule time of motion detection/sound detection incorrect issue when start time > end time
- [Bug Fix] Fixed h.264 streaming issue tested on ios6
- [Bug Fix] Fixed IP task will be restarted issue on DHCP renew time
- [Bug Fix] Fixed OSD disappear issue.
- [Bug Fix] NTP source port change to port 123
- [Bug Fix] Adjust sensor settings
Firmware: 1.01b02 - Date: 05/28/2013
- [New Feature] Update mydlink agent to v2.0.17-b06
- [New Feature] Update h.264 Activex to v1.0.0.12
- [New Feature] Only allow 0-9, a-z, A-Z, “.”, “-“, “_” as the user account name
- [Bug Fix] Fix the problem that mydlink Agent will run twice when the camera is connecting to DIR-850L using WPS Push button
- [Bug Fix] Fixed OSD color issue
- [Bug Fix] Fixed the direction of P/T control panel incorrect issue when Flip/Mirror enabled
Firmware: 1.00b04 - Date: NA/u]