D-Link Forums
The Graveyard - Products No Longer Supported => IP Cameras => DCS-930L => Topic started by: acellier on May 26, 2011, 10:05:13 AM
-
DCS-930L camera disappeared from network.
It is again working after reboot/resync, but no blinking green on back.
Reboot did invoke Blue LED flashes, then steady for a while. Now no light there at all, but camera working.
I think LED on back used to blink green while connected on WiFi, or am I dreaming?
-
Dreaming.
ftp://ftp.dlink.com/Multimedia/dcs930L/Manual/dcs930L_manual_100.zip
-
DCS-930L camera disappeared from network.
It is again working after reboot/resync, but no blinking green on back.
Reboot did invoke Blue LED flashes, then steady for a while. Now no light there at all, but camera working.
I think LED on back used to blink green while connected on WiFi, or am I dreaming?
The DCS-930L web interface (Maintenance -> Admin -> LED Control) has an option to disable the LED. The missing blinking light would be explained if this control is set to "Off".
-
The LED on the back is blue only. The front LED flashes RED, GREEN, or OFF.
-
I think LED on back used to blink green while connected on WiFi, or am I dreaming?
The LED blinks green on the front (not rear) when connected. This feature provides notice to people in the vicinity of the camera that they are being monitored. The on/off control on the web interface permits you to disable the LED for covert viewing. . . i.e. you were dreaming. ;)
-
OK, dreaming. Thanks guys!
Anyone know what different flash patterns mean for the blue LED?
-
The answer is here:
ftp://ftp.dlink.com/Multimedia/dcs930L/Manual/dcs930L_manual_100.zip
-
page 13 says "The blue WPS status LED above the button will blink."
I've seen different numbers of blinks, and steady.