Print

Please login or register.
1 Hour 1 Day 1 Week 1 Month Forever
Login with username, password and session length

[arod]

Warning: This code is used at your own risk. D-Link is not responsible for damage caused to your router or network through its use.


The following beta firmware is provided on a trial basis only and without any kind of warranty. It is heavily advised not to use this beta firmware for any critical purpose.
 By downloading the beta firmware file, you expressly agree that the use of the firmware is at your own risk and discretion.
It is not supported through the normal support channels. All questions, comments and issues should be directed to this board.

This code can ONLY be used with hardware revision B of the WBR-2310

Click the link below to download the code.
ftp://ftp.dlink.com/Gateway/wbr2310_revB/Firmware/wbr2310_revB_firmware_203b02.zip

Click the link below for instructions on how to install firmware.
http://support.dlink.com/faq/view.asp?prod_id=2462&question=DIR-615_revC%20/%20DIR-615%20/%20%20DIR-625%20/%20DIR-635%20/%20DIR-655%20/%20DIR-660

[formulaben]

The download like is corrupted.

[arod]

Where are you downloading it from?

From here or from the support site?

Firmware 2.03 has been posted live on the support site

[formulaben]

Click above and see for yourself.  I get a 550 failure to change directory error.

[raton]

think you sir

[Matthew Doucette]

I cannot update my WBR-2310 router with the new 2.03 firmware update. I have downloaded it from http://www.dlink.ca/products/?tab=3&pid=WBR-2310&rev=WBR-2310_RevB as well as the FTP site linked above in this thread, and even file compared them ("fc" command in DOS) to ensure they are the same. And I have tried over and over to update the router and it gives the same error message every time:

UPLOAD FAILED
The uploaded firmware file may not be correct. You may have uploaded a file that is not intended for this Gateway, or the uploaded file may be corrupted.

If the uploaded file is correct, it is possible that the gateway may be too busy to properly receive it right now. In this case, please try the upload again. It is also possible that you are logged in as a 'user' instead of an 'admin' - only administrators can upload new firmware.

The Gateway will not be reprogrammed.

What should I do? Is this router impossible to update?

My router is already at 2.01 by default.