D-Link Forums
The Graveyard - Products No Longer Supported => IP Cameras => DCS-930L => Topic started by: snapshot on June 14, 2012, 05:16:48 PM
-
I installed my 930L and the camera worked and asked to update firmware. Once done, it asked to download a new active x from the Dlink site.
Even after shutting down my antivirus, firewall and lowering all settings for all zones in I.E., plus entering custom setting for all zones for allowing active X free run, my computer would not download the whole active x. The icon sits on my desktop and will not download from the site. At this point I cant set up settings to record when motion is detected. I can see the view with my Iphone but of course cant run the program from there because it requires flashplayer >:(
Really want to put original firmware in so I can use this for security and view it at home on my computer.
-
Log directly into your camering using its IP address and IE.
Once you log in, go to the page with the view of your camera's image. Above that, you will see two toggles: ActiveX and Java. Click on ActiveX. The correct ActiveX control will download automatically to your PC. You can then click back on Java (if that was what you were using).
You will then be good to go.
Gweezel
-
I tried this but when I Once you log in, go to the page with the view of your camera's image
I am stuck with........ Loading mydlink function.
Great site!
-
It works on my PC/XP and my other laptop XP
Won't load on laptop with Vista IE 9