• April 17, 2024, 08:54:22 PM
  • Welcome, Guest
Please login or register.

Login with username, password and session length
Advanced search  

News:

This Forum Beta is ONLY for registered owners of D-Link products in the USA for which we have created boards at this time.

Author Topic: Not seeing DLNA server  (Read 3058 times)

KTwo

  • Level 1 Member
  • *
  • Posts: 1
Not seeing DLNA server
« on: September 18, 2016, 05:26:16 PM »
I have an 890L (Firmware version 1.10, hardware version A1) serving as the wireless hub for my house.  Configured to get WAN IP from Verizon FIOS router.  DHCP serves IPs to the entire network.  890L is configured as the gateway (192.168.0.1).  All other wireless devices (2 phones, 1 iPad, 4 PCs, 2 Amazon FireTV, 1 Amazon Alexa) connect to the 890L.  Problem is no devices on the 192.168.0.x network can see the DLNA server.  It's enabled in the software.  I have an externally powered 2TB USB 3.0 disk drive hanging off the USB port.  I can map a network drive to the USB drive from all the devices and see all the material on the drive.  But I can't use VLC on any device and stream from a DLNA server because none of the devices see the DLNA server.

This problem occurs with SmartMode on and off - makes no difference.

What am I missing?

Thx
-K2
Logged

FurryNutz

  • Poweruser
  •   ▲
    ▲ ▲
  • *****
  • Posts: 49923
  • D-Link Global Forum Moderator
    • Router Troubleshooting
Re: Not seeing DLNA server
« Reply #1 on: September 19, 2016, 07:12:12 AM »
Link>Welcome!

  • What region are you located?
  • Was a Factory Reset performed before and after any firmware updates then set up from scratch?
  Link> >FW Update Process
  • Was the router working before any firmware updates?

Is uPnP and IPv4 Multicast Streams enabled on the router as well?
Do you use IPv6 any?
Logged
Cable: 1Gb/50Mb>NetGear CM1200>DIR-882>HP 24pt Gb Switch. COVR-1202/2202/3902,DIR-2660/80,3xDGL-4500s,DIR-LX1870,857,835,827,815,890L,880L,868L,836L,810L,685,657,3x655s,645,628,601,DNR-202L,DNS-345,DCS-933L,936L,960L and 8000LH.

FurryNutz

  • Poweruser
  •   ▲
    ▲ ▲
  • *****
  • Posts: 49923
  • D-Link Global Forum Moderator
    • Router Troubleshooting
Re: Not seeing DLNA server
« Reply #2 on: October 04, 2016, 12:56:47 PM »
Any status on this?  ???

Quote from: KTwo on September 18, 2016, 05:26:16 PM
I have an 890L (Firmware version 1.10, hardware version A1) serving as the wireless hub for my house.  Configured to get WAN IP from Verizon FIOS router.  DHCP serves IPs to the entire network.  890L is configured as the gateway (192.168.0.1).  All other wireless devices (2 phones, 1 iPad, 4 PCs, 2 Amazon FireTV, 1 Amazon Alexa) connect to the 890L.  Problem is no devices on the 192.168.0.x network can see the DLNA server.  It's enabled in the software.  I have an externally powered 2TB USB 3.0 disk drive hanging off the USB port.  I can map a network drive to the USB drive from all the devices and see all the material on the drive.  But I can't use VLC on any device and stream from a DLNA server because none of the devices see the DLNA server.

This problem occurs with SmartMode on and off - makes no difference.

What am I missing?

Thx
-K2
Logged
Cable: 1Gb/50Mb>NetGear CM1200>DIR-882>HP 24pt Gb Switch. COVR-1202/2202/3902,DIR-2660/80,3xDGL-4500s,DIR-LX1870,857,835,827,815,890L,880L,868L,836L,810L,685,657,3x655s,645,628,601,DNR-202L,DNS-345,DCS-933L,936L,960L and 8000LH.