D-Link Forums

The Graveyard - Products No Longer Supported => Other D-Link Products => Topic started by: apts on April 09, 2019, 10:06:36 PM

Title: SET UP DLINK (DUAL BAND AC750) ROUTER WITHOUT INTERNET
Post by: apts on April 09, 2019, 10:06:36 PM

I need to set up a LAN with DLINK router, two Ligo wave radios and two Nanostation M2 in a given LAN. NO Internet connection needed.

a. The Radios should all be configured as a REPEATER.  They will not provide IP addresses. Their job should be just to extend the LAN wirelessly. NOTE,  these radios recieve data from  the router via ethernet cable pluged at the back of the router.

b. The router is to provide IP addresses to all connected hosts via DHCP. Both for the radios, mobile devices and laptops that will connect to the LAN wirelessly.  

How do i setup my router to support this LAN and provide IP address from  a range of IP-addresses???

Title: Re: SET UP DLINK (DUAL BAND AC750) ROUTER WITHOUT INTERNET
Post by: FurryNutz on April 10, 2019, 07:09:51 AM

Link>Welcome! (http://forums.dlink.com/index.php?topic=49573.0)

What model DIR router do you have?

• What Hardware version is your router? Look at sticker under the router case.
• Link>What Firmware (http://forums.dlink.com/index.php?topic=47512.0) version is currently loaded? Found on the routers web page under status.
• What region are you located?

DIR series routers do not support repeater mode.