D-Link Forums
The Graveyard - Products No Longer Supported => Access Points / Extenders => DAP-1522 => Topic started by: a2retro on April 16, 2011, 10:20:35 AM
-
Hi I am not sure when this started happening but I seem to have lost connectivity between devices plugged in the DAP-1522. All devices still connect fine over the bridge to the DIR-615 AP and out onto the internet. the AP can ping any of the bridged devices.
I just upgraded to 1.31 but it was also this way on 1.21.
Any suggestions?
Glenn
-
Have you tried unplugging the ethernet cables from the DAP, then reboot the DAP (unplug the power cord). Give it a few seconds, plug it back in, then once all back up and linked to your router (you see the bridge light consistently), individually plug devices in one by one.
-
Hi no I haven't but i will give it a try. I have tried powering off the bridge a few times. I might also try reverting the firmware if nothing else works.
Thanks
-
Hopefully it works and you can re-connect. If not, refer to this............
http://forums.dlink.com/index.php?topic=38153.0 (http://forums.dlink.com/index.php?topic=38153.0)
I've never noticed this :-\, and can't currently go experimenting to check it's validity so I am not sure about it. But if you have problems getting your bridge connection back after restarting the DAP, this may be the cause.
-
Well I have some more info.
If I disable wireless on the DAP-1522 then the local devices can ping each other but of course they cannot access the internet as wireless bridge is down.
The other odd thing is that i set a static ip on the bridge so that i can access the admin web page but when the DAP-1522 connects to the DIR-655 I see a different ip address assigned to that mac address which I find really odd.
-
After swiftly kicking things a few times the DAP-1522 shows up with the correct ip address on the router now but with wireless enabled I am back to having these local systems with no access to each other again.
:'(
-
Try disabling all QoS settings in the DAP menu - then it should work.
-
You nailed it right on. Thanks!!!!
So is this a bug that has been reported to dlink?
Glenn