• March 28, 2024, 09:43:58 AM
  • Welcome, Guest
Please login or register.

Login with username, password and session length
Advanced search  

News:

This Forum Beta is ONLY for registered owners of D-Link products in the USA for which we have created boards at this time.

Author Topic: DCS-950G: motion detection problem  (Read 5344 times)

maitrebart

  • Guest
DCS-950G: motion detection problem
« on: August 06, 2008, 04:35:33 AM »

When I reset the netcam to default factory settings, I then setup the motion detection zones.

After a day or two (or either a few of visits in the motion detection page) I can no longer see the zones' window. Moreover, the OpenMSD monitor does not seem to work anymore.

The sensitivity and percentage values seems ok and to be saved though.

If I go reset the net cam to the default factory settings again, I have to reconfigure everything, including the motion detection zones. And again, after a day or two (or either a few of visits in the motion detection page) I can no longer see the zones' window.

Is anyone experiencing this?

Note: I have firmware 1.07 .
Logged