D-Link Forums

The Graveyard - Products No Longer Supported => Routers / COVR => DGL-4100 => Topic started by: madmartian on July 20, 2010, 11:22:02 PM

Title: DGL-4100 settings for Comcast with Motorola SB6120 modem
Post by: madmartian on July 20, 2010, 11:22:02 PM
Old Setup:
Actiontec M1000 DSL modem setup as a bridge
DLINK DGL-4100 router set to PPPoE

New setup:
Motorola SB6120 cable modem (setup as a bridge?)
DLINK DGL-4100 set to ???

Old Settings:
(http://www.madmartian.com/special/router.jpg)
Title: Re: DGL-4100 settings for Comcast with Motorola SB6120 modem
Post by: Jim1900 on July 30, 2010, 06:05:49 AM
Set the WAN Mode to DHCP.  That way, it will automatically pick up an IP address from you ISP. 

Be sure to reboot everything.  Turn power off, then turn on the SB6120 modem and then the DGL-4100 in that order.  You may have to reboot your PC too as the last step.
Title: Re: DGL-4100 settings for Comcast with Motorola SB6120 modem
Post by: madmartian on July 30, 2010, 09:42:32 AM
I've been hooked up for a few days now, but thanks anyway. Clicking DHCP was indeed all I needed to do. Looks like cable has less configuring to do than DSL. My problem was that I needed to call Comcast and give them my MAC address. That's likely somewhere in the instructions. I didn't even crack the seal on the self install kit. :)