D-Link Forums

The Graveyard - Products No Longer Supported => D-Link Storage => DNR-202L => Topic started by: harrinj on May 11, 2016, 06:37:49 PM

Title: Reset Button
Post by: harrinj on May 11, 2016, 06:37:49 PM
Quick question.  When you push the DNR-202L (and all the camera reset buttons for that matter), does it reset the entire system to include having to enter a new password when you reinstall the hardware?  Just curious...
Title: Re: Reset Button
Post by: FurryNutz on May 11, 2016, 10:08:37 PM
Review the user manual for information on reset buttons and there function. Usually reset buttons clear all configurations and resets devices back to factory settings. So you'll need to re-configure and set up from scratch if you do this. Or load saved configuration files.  ::)
Title: Re: Reset Button
Post by: Kakashi::. on May 12, 2016, 10:11:07 AM
Manuals >  Important to review to know about the RESET button function exactly how it was set to work on that device.

For the most part, RESET buttons are configured to be: 1- Pushed to reboot and 2- Push-and-hold (usually for 7-10 seconds) to RESET-TO-FACTORY or reload factory settings erasing the currently running configuration.

Yes, you will need to set a new password, attached for the cloud services (if Supported) and setup as you did the first time after a FACTORY RESET, unless you save your configuration file,  your are loading this file to a unit running the same firmware and remember the old password (in certain situations) to set the unit back up again.

Let us know if you need any help.