D-Link Forums
The Graveyard - Products No Longer Supported => IP Cameras => DCS-825L => Topic started by: thechilibuddy on November 27, 2015, 04:32:46 AM
-
Hi, all I'm trying to do is to get the damned camera to flip the image since the camera is mounted up against the ceiling so I'm seeing an inverted picture. I've tried to access the webadmin page to get to "Image Setup" but there is no option for that under setup.
So, the only page I seem to be able to access on webadmin is eng/mainFrame.cgi?nav=Setup#
Does anyone have any ideas how I can flip the image or get to a page where I can check that box off? We've got other Dlink cameras and even those have access to advance setting on drink cloud and allows me to flip image.
I've done it before... but I can't for the life of me figure out how I did it the first time... we moved and now I'm stuck again.
-
Is there any information in the user manual about this? ???
-
hi thechilibuddy did you find any way to flip the image on DCS 825L? i have the same problem
-
I don't see anything in the user manual.
ftp://ftp2.dlink.com/PRODUCTS/DCS-825L/REVA/DCS-825L_REVA_MANUAL_1.00_EN.PDF
(ftp://ftp2.dlink.com/PRODUCTS/DCS-825L/REVA/DCS-825L_REVA_MANUAL_1.00_EN.PDF)
-
If you are still having and issue try the webpage below to rotate image 180 degrees (Replace ipaddr with your camera's ip address) login with username admin and the password you set on the camera
http://ipaddr/config/sensor.cgi?flip=on&mirror=on
check
http://ipaddr/config/sensor.cgi
should say flip on and mirror on.
to go back to normal zero degrees try
http://ipaddr/config/sensor.cgi?flip=off&mirror=off