D-Link Forums

The Graveyard - Products No Longer Supported => D-Link Storage => DNR-202L => Topic started by: cathrynm on September 04, 2016, 04:20:37 PM

Title: Ack, I pushed 'Scan Camera'
Post by: cathrynm on September 04, 2016, 04:20:37 PM

And it wiped out all my cameras.  Ugh, how do you add cameras to this thing?  All the instructions are confusing, refer to some other UI.

Title: Re: Ack, I pushed 'Scan Camera'
Post by: BAMoh on September 04, 2016, 05:10:24 PM

Its better to add cams via the GUI rather than the setup wizard. Not sure what you are using. Get the device setup except for the cams then add them via the GUI.

Title: Re: Ack, I pushed 'Scan Camera'
Post by: FurryNutz on September 06, 2016, 06:45:56 AM

Link>Welcome! (http://forums.dlink.com/index.php?topic=48135.0)

• What Hardware version is your DNS? Look at the sticker behind or under the device.
• Link>What Firmware (http://forums.dlink.com/index.php?topic=47512.0) version is currently loaded? Found on the DNSs web page under status.
• What region are you located?

You can log into the DNRs web page and configure cameras there...

Quote from: cathrynm on September 04, 2016, 04:20:37 PM

And it wiped out all my cameras.  Ugh, how do you add cameras to this thing?  All the instructions are confusing, refer to some other UI.