D-Link VPN Router > DSR-250N
Need to Use a second ISP into existing DSR-250
sysut1:
We have a dsr-250. We are getting a second ISP. Is there a
simple device or appliance that would bind 2 isp inputs and either act in load-balance
or failover and then simply output and allow traffic to and from the current wan on the
dsr-250.
GUI is required.
Thanks
FurryNutz:
You might look in to the DSR-500 and 1000AC series routers. They have dual WAN port support.
http://us.dlink.com/products/business-solutions/unified-services-router-w-wan-failover/
sysut1:
At this time we do not want to get a second router. Thanks.
--- Quote from: FurryNutz on December 01, 2017, 12:56:20 PM ---You might look in to the DSR-500 and 1000AC series routers. They have dual WAN port support.
http://us.dlink.com/products/business-solutions/unified-services-router-w-wan-failover/
--- End quote ---
FurryNutz:
The 500 or 1000AC would replace the 250 if your looking for dual WAN support.
sysut1:
We DO NOT want to change our current DSR-250. All we want is to add a device in front of it to handle an additional ISP. Any suggestions as to a device that could be added in front of our current DSP-250 would be appreciated. Thanks
Navigation
[0] Message Index
[#] Next page
Go to full version